Domino / Thermal Printer - BTP-R88NP

Using BTP-R880NP (receipt) printer

Modified on Thu, 4 Jun at 6:29 PM

This article explains how to use the BTP-R88NP thermal printer.

Getting started

Turning the printer on/off

To turn the printer on/off, use the power switch:

BTP-R88NP has a green LED on the device that is on when device is turned on:

Feeding the paper

To feed the paper, press and hold the Feed button:

Paper type

ODP333 uses a thermal printer paper. Paper width is 80 mm. NOTE: Paper type is not the same as the one used for impact (kitchen) printers, such as BTP-M300.

Replacing the paper

To replace the paper, open the printer with the knob that releases the lid:

Insert the paper roll, making sure it's oriented correctly:

Managing BTP-R880NP

Types of cables

Ethernet cable:

When connected to network, the green and yellow LEDs on the Ethernet interface will be on/blinking:

Serial (COM, RS232) cable:

USB cable:

Power Supply Unit (PSU):

PSU has a green LED that is on when PSU is connected to power and operational:

PSU info:

Printing a test page

Printing a test page is a test to make sure the printer is mechanically operational and can print at all. In case test print works, next step to troubleshoot is connectivity.

Turn the printer off by switching the Power button to 0:

Hold the Feed button (the upper one) and at the same time turn the printer on by switching the Power button to I:

Release the Feed button when the test page starts printing.